Physics Practice Problems Projectile Motion: Positive Launch Practice Problems Solution: A 35 g steel ball is held by a ceiling-mounted ...

⚠️Our tutors found the solution shown to be helpful for the problem you're searching for. We don't have the exact solution yet.

# Solution: A 35 g steel ball is held by a ceiling-mounted electromagnet 3.6 m above the floor. A compressed-air cannon sits on the floor, 4.6 m to one side of the point directly under the ball. When a button is pressed, the ball drops and, simultaneously, the cannon fires a 25 g plastic ball. The two balls collide 1.4 m above the floor.What was the launch speed of the plastic ball?

###### Problem

A 35 g steel ball is held by a ceiling-mounted electromagnet 3.6 m above the floor. A compressed-air cannon sits on the floor, 4.6 m to one side of the point directly under the ball. When a button is pressed, the ball drops and, simultaneously, the cannon fires a 25 g plastic ball. The two balls collide 1.4 m above the floor.

What was the launch speed of the plastic ball?

Projectile Motion: Positive Launch

Projectile Motion: Positive Launch

#### Q. You're 6.0 m from one wall of a house. You want to toss a ball to your friend who is 6.0 m from the opposite wall. The throw and catch each occur 1.0 ...

Solved • Mon Oct 29 2018 17:46:39 GMT-0400 (EDT)

Projectile Motion: Positive Launch

#### Q. A physics student on Planet Exidor throws a ball, and it follows the parabolic trajectory shown in the figure . The balls position is shown at 1s inte...

Solved • Mon Oct 29 2018 17:46:37 GMT-0400 (EDT)

Projectile Motion: Positive Launch

#### Q. You are target shooting using a toy gun that fires a small ball at a speed of 15 m/s. When the gun is fired at an angle of 30° above horizontal, the b...

Solved • Mon Oct 29 2018 17:46:28 GMT-0400 (EDT)

Projectile Motion: Positive Launch

#### Q. A projectile is launched from ground level at angle 0 and speed a into a headwind that causes a constant horizontal acceleration of magnitude a opposi...

Solved • Mon Oct 29 2018 17:46:28 GMT-0400 (EDT)